Table of ContentsPreviousNextIndexSearch Knowledge Base

Complete PDF manual
PDF of This Chapter

Step-By-Step Configuration

  1. Configure the DG834 as in the Gateway-to-Gateway procedures using the VPN Wizard (see How to Set Up a Gateway-to-Gateway VPN Configuration), being certain to use appropriate network addresses for the environment.

    2. The LAN Addresses used in this example are as follows:

    Device
    WAN IP Address
    LAN IP Address
    LAN Subnet Mask
    DG834
    14.15.16.17
    10.5.6.1
    255.255.255.0
    FVL328
    22.23.24.25
    172.23.9..1
    255.255.255.0

    1. In Step 1, enter toFVL328 for the Connection Name.
    2. In Step 2, enter 22.23.24.25 for the remote WAN's IP address.
    3. In Step 3, enter the following:
      • IP Address = 172.23.9.1
      • Subnet Mask = 255.255.255.0

        • Figure B-2

  2. Configure the FVL328 as in the Gateway-to-Gateway procedures for the VPN Wizard (see How to Set Up a Gateway-to-Gateway VPN Configuration), being certain to use appropriate network addresses for the environment.
    1. In Step 1, enter toDG834 for the Connection Name
    2. In Step 2, enter 14.15.16.17 for the remote WAN's IP address
    3. In Step 3, enter the following:
      • IP Address = 10.5.6.1
      • Subnet Mask = 255.255.255.0

        • Figure B-3

  3. Test the VPN tunnel by pinging the remote network from a PC attached to the DG834.
    1. Open the command prompt (Start -> Run -> cmd)
    2. ping 172.23.9.1

      Figure B-4

      Note: The pings may fail the first time. If this happens, try the pings a second time.
NETGEAR, Inc.
 http://www.netgear.com
Table of ContentsPreviousNextIndexSearch Knowledge Base 202-10133-01, November 2005