Verify the Hard Disk Is Set to "Cable Select"

The drive jumpers must be set for the "cable select" option, marked "CS" on some drives. Typically, this is the default setting. Follow these steps to verify that the hard disk drive is set to "cable select."

Locate the hard disk jumpers.

Verify that the jumpers are set to "cable select."

The disk housing or documentation will identify which setting is "cable select."

Note: The setting for your drive may differ from this illustratoin. Be sure to consult the documentation provided by the hard disk manufacturer or look on the hard disk to identify which setting is "cable select."

Figure 3-3