Table of ContentsPreviousNextSearch Knowledge Base

Complete PDF manual
PDF of This Chapter


Install the Hard Disk

Warning: Be sure to unplug the power cord from the SC101 before adding or removing the disks. Failure to observe this precaution could render your disks useless.

Follow the steps below to install an IDE hard disk drive into you SC101.

  1. Remove the cover.
    1. Use a coin or screwdriver to open the spring loaded cover lock by turning it clockwise.
    2. Remove the cover.
 

Figure 3-4

  1. Insert the hard disk.
    1. Position the hard disk so that the D-shaped power socket is on the top.
    2. Slide the hard disk into either slot.
 

Figure 3-5

  1. Connect the hard disk cables.

    Figure 3-6

    1. Align and insert the hard disk power cable into the D-shaped power socket.
    2. Align the key of the hard disk data cable with the slot on the data cable socket and insert the cable. Neatly tuck the cables in so that they will not interfere with attaching the cover.
      1. Attach the front cover.
        1. Align the cover with the unit.
        2. Using a screwdriver or coin to hold the spring loaded cover lock open, attach the cover, then release the lock.
       

      Figure 3-7


NETGEAR, Inc.
http://www.netgear.com
Table of ContentsPreviousNextSearch Knowledge Base