Complete PDF manual
PDF of This Chapter

Using the Reset Button to Restore Factory Default Settings

To restore the factory default configuration settings without knowing the login password or IP address, you must use the Default Reset button on the rear panel of the wireless access point (see Figure 2-2 on page 2-7). The reset button has two functions:

Reboot. When pressed and released, the Wireless Access Point will reboot (restart).
Reset to Factory Defaults. This button can also be used to clear all data and restore all settings to the factory default values.

To clear all data and restore the factory default values:

Power off the WAG102 and power it back on.
Use something with a small point, such as a pen, to press the Reset button in and hold it in for at least 5 seconds.
Continue holding the Reset Button until the LEDs blink twice.
Release the Reset Button.

The factory default configuration has now been restored and the WAG102 is ready for use.