Table of ContentsPreviousNextIndexSearch Knowledge Base

Complete PDF manual
PDF of this chapter

Setting up the WAG102 Wireless Access Point
Tip: Before mounting the WAG102 in a high location, first set up and test the WAG102 to verify wireless network connectivity.

To set up the WAG102 Wireless Access Point:

  1. Prepare a computer with an Ethernet adapter. If this computer is already part of your network, record its TCP/IP configuration settings.
  2. Configure the computer with a static IP address of 192.168.0.210 and 255.255.255.0 for the Subnet Mask.
  3. Connect an Ethernet cable from the WAG102 to the computer.
  4. Turn on your computer, connect the power adapter to the WAG102 and verify the following:
    • The PWR power light goes on.
    • The LAN light of the wireless access point is lit when connected to a powered on computer.
    • The WLAN LEDs should be blinking.
NETGEAR, Inc.
 http://www.netgear.com
Table of ContentsPreviousNextIndexSearch Knowledge Base 202-10120-02, September 2006