Table 3-1. General Information Fields
|
Field
|
Description
|
|
Access Point Information
|
| |
Access Point Mode
|
Shows the current operating mode of the device: AP, Bridge, Repeater or Client.
|
|
Access Point Name
|
The default name can be changed if desired.
|
|
MAC Address
|
Displays the Media Access Control address (MAC Addresses) of the wireless access point's Ethernet port.
|
|
Region
|
Displays the country or region for which the wireless access point is licensed for use. It may not be legal to operate this wireless access point in a region other than one of those identified in this field.
|
|
Firmware Version
|
The version of the firmware currently installed.
|
|
Current IP Settings - These parameters apply to the Local WG602v4 wireless access point.
|
| |
IP Address
|
The IP address of the wireless access point.
|
|
Subnet Mask
|
The subnet mask for the wireless access point.
|
|
Default Gateway
|
The default gateway for the wireless access point.
|
|
DHCP Client
|
Enabled by default. Enabled (DHCP client) indicates that the current IP address was obtained from a DHCP server on your network.
|
|
Wireless Settings - These parameters apply to the target remote WG602v4, VPN gateway, or VPN client.
|
| |
Wireless Network Name (SSID)
|
Displays the wireless network name (SSID) being used by the wireless port of the wireless access point. The default is NETGEAR.
|
|
Associated AP (Client mode only)
|
The MAC address of a remote AP or peer that this wireless access point is connected to.
|
|
Channel
|
Identifies the channel the wireless port is using.
|
|
Encryption Type
|
The current encryption setting.
|
|
Access Control
|
Restricts wireless access by MAC address. Disabled by default.
|
