Complete PDF manual
PDF of this chapter

Appendix A
Default Configuration and Technical Specifications

Default Configuration Settings

You can use the reset button located on the front of your device to reset all settings to their factory defaults. This is called a hard reset.

To perform a hard reset, push and hold the reset button for approximately 5 seconds (until the TEST LED blinks rapidly). Your device will return to the factory configuration settings shown in Table A-1. below.
Pressing the reset button for a shorter period of time will simply cause your device to reboot.

Table A-1. Access Point Default Configuration Settings

Feature		Description
AP Login
	User Login URL	192.168.0.227
	User Name (case sensitive)	admin
	Login Password (case sensitive)	password
	Access Point Name	NETGEARxxxxxx where xxxxxx are the last six digits of the WG602v4 MAC address
Ethernet Connection
	Ethernet MAC Address	See bottom label.
	Port Speed	10/100
Local Network (LAN)
	Lan IP	192.168.0.227
	Subnet Mask	255.255.255.0
	DHCP Client	Enabled
Wireless
	Wireless Communication	Enabled
	Wireless Network Name (SSID)	NETGEAR
	Security	Disabled
	Broadcast SSID	Enabled
	Transmission Speed	Auto1
	Country/Region	United States (in North America; otherwise, varies by region)
	RF Channel	11 until the region is selected
	Operating Mode	802.11b/802.11g
	Data Rate	Best
	Output Power	Full
	Access Point Mode	Access Point
	Wireless Card Access List	All wireless stations allowed
	MAC Address Filtering	Disabled
	WMM Support	Disabled
	Spanning Tree Protocol	Enabled

1Maximum Wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput will vary. Network conditions and environmental factors, including volume of network traffic, building materials and construction, and network overhead, lower actual data throughput rate.

202-10279-01, June 2007