Complete PDF manual
PDF of This Chapter

Prepare for Installation

Carefully peel off the protective film covering both sides of your bridge

Figure 1

Set up your bridge by inserting the tabs of the stand into the slots on its bottom as shown. Then, remove the protective film covering the status light panel.

Figure 2

Place your bridge in a suitable area for installation (near an AC power outlet and accessible to the Ethernet cables for your wired connections).

Note: To ensure proper heat dissipation and for bridge stability, it is important that you connect the stand, place your bridge in an upright position, and do not block the vent holes at the top.

202-10300-01, May 2008